1/4-inch Carbide Double Cut Burr for Tire Repair Dressing with Adapter

In stock
SKU: 18241A
Regular price $23.99

  • REMOVE DEBRIS - used to remove debris and clean out the channel of damage caused during a tire puncture
  • CREATE A UNIFORM CHANNEL - Creates a clean, smooth, and uniform 1/4-inch wide channel for a better seal when using tire repair plug stems and stem patches
  • ADAPTER INCLUDED - With included adapter this tool can be used with a standard 3/8-inch quick change chuck on most low speed buffer tools, including the STEELMAN SLP6510
  • DURABLE CARBIDE STEEL - The burr is made of durable carbide steel to stand up to hard use
  • DOUBLE CUT DESIGN - Double cut design of the burr tip allows it to cut on both insertion and removal strokes during tire repair
  • REPAIR LARGER INJURIES - Can be used to repair tire injuries larger than 1/8-inch up to the RMA recommended maximum of 1/4-inch
One of the steps in the Rubber Manufacturers Association tire repair procedure for pneumatic tires is to ensure the tire injury is cleaned out in preparation for a plug stem or plug stem patch. The STEELMAN 1/4-inch Carbide Double Cut Burr for Tire Repair Dressing with Adapter is designed for this specific step of tire repair. A 2mm hex set screw holds the carbide burr firmly in place inside the adapter, which can then be swapped into a 3/8-inch quick-change chuck on a low-speed tire buffer. Create a clean, smooth, and uniform repair channel through the tire rubber and embedded steel belts without the risk of friction scorching. The double-cut design removes material on both the insertion and removal parts of each stroke to speed up repair time. The durable carbide steel burr features flats along the shaft to ensure that the set screw has a secure purchase and will keep the burr from being seized by the tire material.